4. operation
WarninG:
Remove battery before fitting tool or maintenance is carried out.
4.1.
To remove the battery from the equipment, depress the spring loaded button on the battery pack. Remove the battery pack by sliding
out.
Do not
touch the metal battery terminals.
4.2.
uSinG the Drill
9
ensure that you have read, understood and comply with all the safety instructions in Section 1.
4.2.1. ensure the direction switch (2) is in the mid (lock) position. Pull the chuck collar back and insert the required bit.
4.2.2. Select hammer or drill using rotary switch (1).
4.2.3. Select the direction of rotation by means of the direction switch (2).
4.2.6.
The led worklight is lit whenever the trigger is depressed.
4.2.8.
When finished, remove the bit, clean the drill and bit and replace the drill in its case.
4.2.9.
Store in a cool, dry place out of the reach of children.
5. maintenance
WarninG:
Always disconnect from power source before carrying out any inspection, maintenance or cleaning.
5.1.
General inSpection
5.1.1.
Regularly check that all the fixing screws are tight.
5.1.2.
Repairs should be carried out by an authorised service centre.
5.2.
cleaninG
WarninG:
Always wear protective equipment including eye protection and gloves when cleaning this tool.
5.2.1.
Keep your tool clean at all times. dirt and dust will cause internal parts to wear quickly, and shorten the device’s service life.
5.2.2.
Clean the body of your machine with a soft brush, or dry cloth.
5.2.3.
Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild detergent on a damp cloth is recommended.
5.2.4.
Water must never come into contact with the tool. ensure the tool is thoroughly dry before using it.
5.2.5.
If available, use clean, dry, compressed air to blow through the ventilation holes (where applicable).
5.3.
lubrication
5.3.1.
lightly lubricate all moving parts at regular intervals with a suitable spray lubricant.
5.4.
bruSheS
5.4.1.
over time the carbon brushes inside the motor may become worn.
5.4.2.
excessively worn brushes may cause loss of power, intermittent failure, or visible sparking.
5.4.3.
If you suspect that the brushes may be worn, have them replaced at an authorised service centre.
5.5.
StoraGe
5.5.1.
Store this tool carefully in a secure, dry place out of the reach of children.
Original Language Version
© Jack Sealey limited
