![background image](http://html1.mh-extra.com/html/sealey/black-series/black-series_instructions_1225908002.webp)
INITIAL OPERATION:
4.2 Power On.
4.2.1
Place the wrench on a horizontal level surface
and press the button to turn on the torque
wrench.
4.2.2 Press the button again to turn the
wrench off.
SET-UP
4.3
Track Mode:
After turning on the torque
wrench it will be set in
’track’
mode.
This means once the torque is reached and
pressure is taken off the torque wrench the
display rolls back down to ZERO.
4.4
Peak Hold Mode:
use the wrench in exactly
the same way, except that when the force is
released, the display stays at the maximum
torque that has been applied.
After two seconds the display will flash. Either
continue on the next operation or press the
button to ZERO the value and continue onto
the next operation.
4.5 Track and Peak Mode Setting.
4.5.1 Press the button to turn the wrench on.
4.5.2 Cycle the button to select peak or track.
Press to confirm.
Note: If no buttons are pressed within 10
seconds the display will return to the main
screen.
4.6 Unit Selection.
4.6.1 Press the button for 3 seconds
4.6.2 When the peak or track mode has been
confirmed the wrench will go to unit selection.
4.6.3 Nm will be shown, Press the button to
scroll through different measurements.
4.6.4 Press the button to confirm.
If no buttons are pressed within 3 seconds
the display will return to the main screen.
4.6.5 After confirming, the screen will automatically
move onto the next setting (Auto Power Off).
4.7 Auto Power Off
4.7.1 When the unit selection has been confirmed
the wrench will go to Auto Power Off setting.
4.7.2 On the auto power off screen the default time
will be shown (5 minutes).
4.7.3 Press the button to scroll through the
settings.
5 Minute 15 Minutes No Auto
Power Off
4.7.4 To confirm, press the button.
If no buttons are pressed within 3 seconds
the display will return to the main screen.
4.7.5 After confirmation, the screen will return to the
main screen.
Nm
lbf.ft
lbf.in
kgf.m
Original Language Version
STW306B Issue: 2(I) - 20/06/17
© Jack Sealey Limited
Display-:
A:
REAL TIME TORQuE VALuE
B:
THE uNIT OF ANGLE
C:
TORQuE uNITS
D:
TARGET TORQuE INDICATOR
E:
TARGET ANGLE INDICATOR
F:
MEMORY STORAGE NuMBERS
G:
BATTERY INDICATOR
H:
PEAK / TRACK MODE
I :
MINuS SYMBOL A.C.W. ROTATION
Control panel-:
1:
POWER ON/OFF
2:
MEMORY PRESETS/SETTING
SELECTION
3:
MEMORIZE TORQuE or ANGLE
CHANGE ROTATION
4:
ZERO TORQuE/ANGLE
5:
*BACK LIGHT/NEXT DIGIT SELECT/
ENTER ANGLE MODE
* Hold down for 3 seconds “on” / 2 seconds “off”.
A
B C
D E
F
G H I
1
4
2
3
5
The Wrench
NEW USER NOTES:
Familiarise yourself with the display and control panel.
Practice setting up by holding the torque wrench 1/2”
drive in a vice. Set units, torque, angle figures and
test for visual, audible, vibration signals by sweeping
the torque arm.