3-IN-1 BUTANE INDEXING SOLDERING IRON
MODEL NO:
AK2970
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
equipment, make sure you know where the nearest fire extinguisher is.
WARNING!
Always wear approved eye/ face protection when operating the torch.
WARNING!
DO NOT
use the torch if you notice that it is damaged or if there could be a gas leak from it.
WARNING!
Butane gas is extremely flammable, handle with care.
WARNING!
Always point the torch away from the eyes and body when igniting and during operation.
WARNING!
DO NOT
put the torch down when it is lit,
DO NOT
leave it unattended.
WARNING!
The flame is not easily visible in bright daylight.
WARNING!
Ensure the flame is completely extinguished after use.
DO NOT
use water to cool the torch down.
WARNING!
Only use in a well ventilated area.
8
DO NOT
use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard.
Keep flammable material away from the torch when operating.
8
DO NOT
operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT
hold any workpiece by hand.
8
DO NOT
touch the workpiece close to the heated area as it will be very hot. Allow to cool.
8
DO NOT
operate the torch if it is damaged as this may cause failure and/or possible personal injury.
8
DO NOT
touch the top of the torch during or immediately after use, as it will be very hot. Allow to cool.
8
DO NOT
allow children to operate the torch.
9
After use, allow the torch to cool before storing it.
9
When not in use, store away from direct sunlight in a safe, dry, childproof location.
8
DO NOT
store at over 40°C, such as in a car in hot weather.
8
DO NOT
modify the appliance.
9
The appliance should be operated away from flammable materials
9
When filled, it will contain flammable gas under pressure
8
DO NOT
puncture or put in fire.
9
Make sure the fire is off before refilling.
8
DO NOT
keep lit for more than 5 minutes.
9
Make sure the fire is off before refilling.
9
Allow the micro torch to cool down before storage. Storing the appliance in well ventilated area and ensure the flame is over after the
operation.
9
Use only Sealey original spare parts.
8
DO NOT
use torch as a cigarette lighter.
9
Be extra careful when using the torch outdoors on sunny or windy days. Wind may carry the torch’s heat back toward you or other
areas which are not intended to be heated.
9
Always check to make sure no unintended parts or materials are being heated.
9
Whenever there is a possibility that unintended material has been heated, wait at least two hours before leaving the area.
8
DO NOT
inhale soldering fumes.
9
Follow refilling procedure to avoid serious accidents.
2. INTRODUCTION
3-in-1 device that can be used for heating, soldering and shrinking. Fitted with indexing head for three different positions as well as magnetic
stand. Powered by butane (lighter fuel) and features a piezoelectric ignition switch. Viewing window at bottom of device to monitor fuel. Flame
temperature 1300°C, soldering temperature 450°C and hot air temperature of 600°C (Approximately). 60-75 Minute run time with 30ml fuel
capacity.
3. SPECIFICATION
MODEL NO: .............................................................AK2970
Height:
.......................................................................
260mm
A
K2970 Issue 1 16/07/2020
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Hot surfaces
Wear eye
protection
Wear protective
gloves
