AK2933 Issue: 1 - 25/05/17
Original Language Version
© Jack Sealey Limited
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
Refer to Instruction
Manual
Wear Eye
Protection
Warning:
Hot Surface
Warning:
Flammable Material
1. SAFETY
INSTRUCTIONS FOR:
ELECTRONIC MICRO SOLDERING TORCH
MODEL NO:
AK2933
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment,
make sure you know where the nearest fire extinguisher is.
WARNING!
Always wear approved eye / face protection when operating the torch.
WARNING! DO NOT
use the torch if you notice damage to the workpiece or if there could be a gas leak from it.
WARNING!
Butane gas is extremely flammable, handle with care.
WARNING!
Always point the torch away from the eyes and body when igniting and during operation.
WARNING! DO NOT
put the torch down when it is lit,
DO NOT
leave it unattended.
WARNING!
The flame is not easily visible in bright daylight.
WARNING!
Ensure the flame is completely extinguished after use.
DO NOT
use water to cool the torch down.
WARNING!
Only use in a well ventilated area.
DO NOT
use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard. Keep
flammable material away from the torch when operating.
DO NOT
operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT
hold any workpiece by hand.
DO NOT
touch the workpiece close to the heated area as it will be very hot. Allow to cool.
DO NOT
operate the torch if it is damaged as this may cause failure and/or possible personal injury.
DO NOT
touch the tip of the torch during or immediately after use, as it will be very hot. Allow to cool.
DO NOT
allow children to operate the torch.
After use allow the torch to cool before storing it.
When not in use, store away from direct sunlight in a safe, dry, childproof location.
DO NOT
store at over 40°C, such as in a car in hot weather.
2. INTRODUCTION
Piezoelectric ignition with 1300°C burner flame adjustable from 12 to 35mm. Fitted with safety lock and continuous use switch for easy operation.
Standard fill gives approximately 30 minutes continuous operation. Powered by Butane (lighter fuel).
3. OPERATION
fig.1
fig.2
