INSTRUCTIONS FOR:
ADJUSTABLE JACK SADDLE
Models:
ADT1 & ADT2
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
ADT1 & ADT2 - (0001) - (2) - 1007011
1. SAFETY INSTRUCTIONS
IMPORTANT!
ENSURE YOU READ AND UNDERSTAND THESE INSTRUCTIONS FULLY BEFORE ATTEMPTING TO USE
THE JACK SADDLE. NOTE THE SAFE OPERATIONAL REQUIREMENTS, DANGERS, WARNINGS AND CAUTIONS.
USE THE SADDLE CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
p
WARNING!
FAILURE TO APPLY THESE INSTRUCTIONS MAY CAUSE
DAMAGE AND/OR SERIOUS PERSONAL INJURY.
FAILING TO FOLLOW INSTRUCTIONS WILL ALSO INVALIDATE YOUR WARRANTY. KEEP THESE INSTRUCTIONS SAFE
FOR FUTURE USE.
2. INTRODUCTION & SPECIFICATIONS
The ADT1 and ADT2 Adjustable Saddles have been manufactured to a high
specification to fit Sealey Vertical Transmission Jacks, in place of the standard fixed
saddle, thereby increasing the range of transmissions which can be accommodated.
ADT1
ADT2
Rated capacity . . . . . . . . . .300kg . . . . . . .750kg
Saddle width . . . . .140 to 360mm .140 to 425mm
Saddle length . . . . . . . . .350mm . . . . . .530mm
Saddle pitch & tilt . . . . . . . . . .20
O
. . . . . . . . .20
O
p
WARNING! Ensure all preliminary checks are carefully carried out before using
saddle and jack. Immediately repair or replace damaged or missing parts (use
authorised service agent). Ensure use of
genuine parts only. Unauthorised parts
may be dangerous and will invalidate the warranty.
p
WARNING! Follow the safety instructions issued with the transmission jack.
Before use ensure the transmission weight and size do not exceed the capacity of the
saddle or the jack.
p
WARNING! Ensure load is placed level and centrally on saddle and is fixed in
place before attempting to lift, lower, or transport.
Always use load restraint chain and attachments to stabilise and secure the
load to the saddle.
DO NOT
use the saddle without restraint chain.
DO NOT
replace the chain with an inferior form of restraint.
Care should be taken when using the saddle and vertical transmission jack in conjunction
with a vehicle lift to ensure that the vehicle is not lowered whilst the jack is in position.
DO NOT
move the jack, with or without a load, with the saddle in the raised position.
DO NOT
use the saddle for any purpose other than for vehicle transmissions.
Before storing ensure saddle is clean and free of grease and oil.
NOTE:
The use of symbols in this document is to attract your attention to possible danger. The symbols and warnings themselves do not eliminate any danger, nor
are they substitutes for proper accident prevention measures.
ADT1
ADT2
To suit Sealey jacks . . . . .300GA . . . . .1000GA
600GA
1250GA
1000GA
1250GTA
1250GA
1250GTA
01284 757500
E-mail:
01284 703534
Sole UK Distributor, Sealey Group,
Bury St. Edmunds, Suffolk.
APPLICATIONS:
SPECIFICATIONS:
ADT1
ADT2
