16
© Sealevel Systems, Inc. 7803e Manual | SL9250 11/2022
Appendix C – Electrical Interface
RS-232
Quite
possibly the most widely used communication standard is RS-232. This implementation has been
defined and revised several times and is often referred to as RS-232-C/D/E or EIA/TIA-232-C/D/E. It is
defined as “Interface between Data Terminal Equipment and Data Circuit- Terminating Equipment
Employing Serial Binary Data Interchange”. The mechanical implementation of RS-232 is on a 25-pin D sub
connector. The IBM PC computer defined the RS-232 port on a 9 pin D sub connector and subsequently the
EIA/TIA approved this implementation as the EIA/TIA-574 standard. This standard has defined as the
“9-Position Non-Synchronous Interface between Data Terminal Equipment and Data Circuit-Terminating
Equipment Employing Serial Binary Data Interchange”. Both implementations are in widespread use and
will be referred to as RS-232 in this document. RS-232 is capable of operating at data rates up to 20K bps
/ 50 ft. The absolute maximum data rate may vary due to line conditions and cable lengths. RS-232 often
operates at 38.4K bps over very short distances. The voltage levels defined by RS-232 range from -12 to
+12 volts. RS-232 is a single ended or unbalanced interface, meaning that a single electrical signal is
compared to a common signal (ground) to determine binary logic states. A voltage of +12 volts (u3
to +10 volts) represents a binary 0 (space) and -12 volts (-3 to -10 volts) denote a binary 1 (mark). The
RS-232 and the EIA/TIA-574 specification define two types of interface circuits Data Terminal Equipment
(DTE) and Data Circuit-Terminating Equipment (DCE). The Sealevel Systems Adapter is a DTE interface.
