The propellers are fitted with easy screw on/screw off attachments and the motors have the
matching part.
Release System
The release line is permanently attached to the left
bottom side of the drone and the release is on the
right-hand side of the drone.
There is a loop at the end of the release line that
loops over the forward arm of the release horn.
Ensure the line stays forward of the release horn so
it doesn’t tangle on release.
Attaching the Propellers
Match the colours of the attachment on the propellers to the matching colour on the motors.
Match silver to silver and gold to gold.
The propellers screw on in the opposite direction to the rotation of the motor. The front left will
screw on counter-clockwise and the front right screws on clockwise. The propellers will self tighten
as the motors are running. The screw thread runs the same direction of the pitch on the prop.
Follow the pitch of the propeller - Wind the prop backwards and down to fit, and up and forward
to remove.
To remove the propellers, hold the motor and push the propeller in the direction of normal
rotation. Front left is clockwise to remove.
Connecting the Battery
The battery is installed into the battery compartment situated on the bottom of the EX-2
KontikiDrone.
•
Remove the Quick Switch plug.
•
Turn the drone upside down inside the backpack and not to put the motors in the sand.
•
Undo the quick release screw, slight the retainer back and open the battery compartment.
•
Insert the battery and connect the to the XT90 plug.
•
Tuck in wires and slide the lid back into place and secure with the quick release tab.
•
If you want a fully waterproof battery compartment, use the four screws provided and
screw into the four screw holes.
Page 17
Summary of Contents for EX-2 Pro
Page 10: ...Page 10...
Page 36: ...Page 36...
