1.9"(4.8 cm)
FP FAUCET
PART NUMBER
Chrome 707203
.725" (1.9 cm)
7.4"
(18.8 cm)
6.0"
(15.3 cm)
2.1"
(5.3 cm)
4.1"
(10.4 cm)
Cut out faucet base pattern and use for rough position. Tape pattern
in place. Then, for final positioning, place faucet on pattern on top
of sink and check for correct orientation of faucet body, spout and
handle. This final positioning is needed before making your
installation hole.
It is important to note control handle position and “throw” to
insure adequate clearance.
Also note the “swing feature” of the faucet’s spout that allows many
different mounting options.
Make sure of all clearances above
and below
sink before drilling
mounting hole.
Mounting Hole Pattern for
FP Faucet
PATTERN OF BASE OF FP FAUCET SHOWING HOLE
LOCATION (ACTUAL SIZE)
Faucet Care Instructions
All General Ecology, Inc. purifiers feature lead free ports and faucets.
Faucets are manufactured with the finest components available.
However, they require proper care to keep them looking their best.
If properly cared for, these finishes can provide a lifetime of elegance.
Chrome finishes can be damaged by abrasive cleaners, in spite of their
hardness. To clean faucet surfaces properly, use a small amount of a
non-abrasive liquid detergent and a soft wet cloth. Gently rub the soiled
surface until the dirt is removed. Then rinse clean and wipe with a dry
soft cloth to remove water drops and to prevent spotting. Do not use
any abrasive or pumice type cleansers to clean the surfaces of these
faucets, or you may permanently scratch or otherwise damage the faucet
coating. Hard water may leave mineral deposits or “water spots”. If
not cleaned regularly, these deposits may resist cleaning with simple
liquid detergents. These can usually be removed using a small amount
of vinegar applied directly and rubbing with a soft cloth. Heavy deposits
may require repeated applications.
© 2004 General Ecology, Inc. • ®, ™ Trademarks of General Ecology, Inc. • All health claims not in accordance with local or state laws are hereby withdrawn. • 200712 revB 9/07
SEAGULL
®
IV X-1F Positioning and
Dimension Information
1.9" (4.8 cm)
Base Diameter
.75" (1.9 cm.) Hole Diameter
6
Other Great Products Available
from General Ecology, Inc.
(610) 363-7900 • fax (610) 363-0412 • www.generalecology.com
2.9"
(7.3 cm)
5"
(12.7 cm)
4.1"
(10.5 cm)
5.4"
(13.7 cm)
2.5"
(6.4 cm)
X-1F PRESSURE VESSEL
AS9100, ISO 9001 and FAA Quality Certified PMA Manufacturer
