www.seagullmodels.com
23
ELEVATOR - RUDDER PUSHROD HORN
INSTALLATION.
C/A glue.
Hinge.
4) When you are sure that everything is
aligned correctly, mix up a generous amount of
Flash 30 Minute Epoxy. Apply a thin layer to the
mounting slot and to bottom of the vertical sta-
bilizer mounting area. Apply epoxy to the bot-
tom and top edges of the filler block and to the
lower hinge also. Set the stabilizer in place
and realign. Double check all of your measure-
ments once more before the epoxy cures. Hold
the stabilizer in place with T-pins or masking
tape and remove any excess epoxy using a
paper towel and rubbing alcohol. Allow the ep-
oxy to fully cure before proceeding.
Epoxy.
1) Install tail struts included with your ARF.
Cut small slot from the two indentations on
the bottom of the horizontal tail.
2) And also cut small slot from the
indentation on both sides of fuselage as
shown.
Cut.
Cut.
