YAK 3
Instruction Manual.
24
INSTALL RUDDER CONTROL HORN.
Repeat steps to install the rudder con-
trol horn as same as steps done for ailer-
Rudder fiberglass control horn.
Epoxy.
INSTALLING VERTICAL STABILIZER
1) Using a modeling knife, remove the
covering from over the precut hinge slot
cut into the lower rear portion of the fu-
selage. This slot accepts the lower rudder
hinge.
Remove covering.
2) Slide the vertical stabilizer into the slot in
the top of the fuselage. The rear edge of the
stabilizer should be flush with the rear edge
of the fuselage and the lower rudder hinge
should engage the precut hinge slot in the
lower fuselage. The bottom edge of the stabi-
lizer should also be firmly pushed against the
top of the horizontal stabilizer.
Fill Epoxy
Fiberglass control horn
