ULTRA JET
Instruction Manual.
20
2
120mm.
5) Apply the epoxy to the surface of both tail
and wing end. The tail is held in position and
install it to the wing end. Please see pictures
shown.
Fill epoxy.
Fill epoxy.
INSTALLATION PILOT AND CANOPY.
2
1
1) Locate items necessary to install pilot, and
canopy.
2) A scale pilot is included with this ARF. The
Seagull Pilot included fitting well to the cockpit.
(or you can order others scale pilot figures
made by Seagull factory. They are available at
Seagull distributors.)
3) Position the pilot figure on the canopy floor
as show. Locate the oval shaped on the canopy
floor and remove the covering. Use epoxy to
glue this into the base of the pilot figure and
glue the cockpit panel in place with C/A glue,
please see pictures as shown.
If you are going to install a pilot figure, please
use a sanding bar to sand the base of the figure
so that it is flat.
Fill epoxy.
When cutting through the covering to re-
move it, cut with only enough pressure
to only cut through the covering itself. Cutting
into the balsa structure may weaken it.
Remove covering.
