Seagull Models P-26A PEASHOOTER, Assembly Manual

Page: 26 / 38

P-26A Peashooter
Instruction Manual.
26
2) Using a modeling knife, carefully re-
move the covering at mounting slot of
vertical stabilizer.
Fill Epoxy
When cutting through the covering to re-
move it, cut with only enough pressure to only
cut through the covering itself. Cutting into
the balsa structure may weaken it.
Fiberglass control horn
INSTALL RUDDER CONTROL HORN.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
5) When you are sure that everything is
aligned correctly, mix up a generous
amount of Flash 30 Minute Epoxy. Ap-
ply epoxy to the bottom and top edges
of the filler block. Set the stabilizer in
place and realign. Double check all of
your measurements once more before
the epoxy cures. Hold the stabilizer in
place with T-pins or masking tape and
remove any excess epoxy using a paper
towel and rubbing alcohol. Allow the
epoxy to fully cure before proceeding.
3) Slide the vertical stabilizer back in-
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90º
to the horizontal stabilizer.
Epoxy