11
www.seagullmodels.com
6) Slide the threaded end of the axle
through the hole in the bottom of the landing
gear leg. Use a washer and locknut to tighten
the axle to the landing gear. Make sure to use
threadlock on the nut so it won’t vibrate loose
in flight as shown.
C/A glue.
Landing Gear.
wheel Pant.
Locker glue.
7) Tighten the setcrews using a hex
wrench to secure the collars on the axle over
the flat spot to retain the wheel as shown.
Repeat steps as above to attach remain-
ing wheel pants to the landing gear.
INSTALLING THE MAIN LANDING GEAR
TO FUSELAGE.
8) The blind nuts for securing the landing
gear are already mounted inside the fuselage.
9) Using the hardware provided, mount
the main landing gear to the fuselage.
10) Place the fuselage inverted on the
workbench in a suitable stand. Set the landing
gear in place and use a screwdrive to secure
the landing gear to the fuselage using bolts
M4x20mm and washers. Make sure to use the
threadlock on the bolts so they don’t vibrate
loose.
Thread locker glue.
