Seagull Models FOCKE-WULF FW190, Assembly Manual

Page: 15 / 37

15
.
INSTALLING THE ENGINE SWITCH
Switch
Trim and cut
Switch
3 .
1 .
2 .
INSTALLING THE STOPPER
ASSEMBLY
Using a modeling knife, carefully cut
of the rear portion of one of the 3 nylon
tubes leaving 1/2” protruding from the
rear of the stopper. his will be the fuel
pick up tube.
Using a modeling knife, cut one length
of silicon fuel line. Connect one end of
the line to the weighted fuel pick up and
the other end to the nylon pick up tube.
2 .
1 .
Carefully bend the second nylon tube up at
a 45º angle. his tube is the vent tube.
3 .
Vent tube
Fuel ill tube
Fuel pick up tube
Test it the stopper assembly into the tank.
It may be necessary to remove some of the
lashing around the tank opening using a
modeling knife. If lashing is present, make
sure none falls into the tank.
With the stopper assembly in place, the
weighted pick-up should rest away from the
rear of the tank and move freely inside the
tank. he top of the vent tube should rest just
below the top of the tank. It should not touch
the top of the tank.