CHEROKEE
Instruction Manual.
26
C/A glue.
1.
2.
3.
4.
INSTALL THE PLASTIC PARTS.
3.
2.
4.
30mm
.
110mm.
C/A glue.
Epoxy.
4) Set the pilots and seats in place and use
epoxy to glue into the base of the pilot figures
and seats as below picture.
- Apply a bead of canopy glue around the inside
edge of the canopy. Position the canopy onto
the hatch. Use tape to hold the canopy secure
until the glue fully cures.
6) Install the canopy and secure it with M2x6mm
screws.
C/A glue.
1.
5.
M2x6mm.
3) Trim the instrument panel and apply it into
position with C/A glue.
5) Position the canopy onto the fuselage. Trace
around the canopy and onto the fuselage using
a felt-tipped pen.
1) Locate the items neccessary to install the
plastic parts included with your models:
1) A scale pilot is included with this ARF. The
Seagull Pilot included fitting well to the cockpit.
(or you can order others scale pilot figures
made by Seagull factory. They are available at
Seagull distributors.)
If you are going to install a pilot figure, please
use a sanding bar to sand the base of the figure
so that it is flat.
2) Position the pilot figure on the canopy floor
as show.
