Seagull Models Cessna Turbo Skylane 182, Assembly Manual

Page: 21 / 45

21
5 .
Fuel pick up tube
Fuel ill tube
Vent tube
- Connect the lines from the tank to the
engine and muler. he vent line will
connect to the muler and the line from
the clunk tothe carburetor.
Blow through one of the lines to ensure
the fuel lines have not become kinked inside
the fuel tank compartment. Air should low
through easily.
MOUNTING THE ENGINE
- Position the engine with the drive wash-
er (120mm) forward of the iewall as
shown.
- Use a pin drill and 4mm drill bit to drill
a small indentation in the mount for the
engine mounting screw.
1 .
120mm
- Use a drill to drill the four holes in the
engine mount rails.
2 .
4mm
3 .
- On the ie wall has the location for the
throttle pusshrod tube (pre-drill).
- Slide the pushrod tube in the iewall and
guide it through the fuel tank mount. Use
medium C/A to glue the tube to the ie-
wall and the fuel tank mount.
- Connect the Z-bend in the 450mm
throttle pushrod to the outer hole of the
carburetor arm.
- Slide the throttle pushrod wire into the
tube. Position the engine between the
mounts. Use four M4x30mm machine
screws to secure the engine to the mount
as shown.