16
TapeStor 8GB Installation Manual
Configuring the SCSI drive
Before you install your SCSI drive, you may need to
configure the drive by changing jumper or dip-switch
settings.
Set
Set
Set
Set
Set the SCSI I
the SCSI I
the SCSI I
the SCSI I
the SCSI ID number f
D number f
D number f
D number f
D number for
or
or
or
or the
the
the
the
the tape driv
tape driv
tape driv
tape driv
tape driveeeee.....
Each SCSI device attached to a SCSI cable must have a
unique SCSI ID number (from 0 to 7) assigned to it.
This tape drive is configured at the factory for SCSI ID 4.
You can assign the drive any SCSI ID number that is
not being used by another SCSI device.
To change the SCSI ID, set the jumpers on the SCSI
jumper block as shown at left.
Note
Note
Note
Note
Note..... In general, you should not use SCSI ID 7, which
is normally used by the SCSI controller, or SCSI
ID 0, which may be used by the computer’s
bootable hard drive.
SCSI ID 0
SCSI ID 1
SCSI ID 2
SCSI ID 3
SCSI ID 4*
SCSI ID 5
SCSI ID 6
SCSI ID 7
Jumper
Positions
Pin 1
Note: Drive is upside down
* Default is SCSI ID 4
a
8gbig.pm6
7/14/97, 3:43 PM
16
