20
Elite 47 Installation Guide, Rev. B
Most Elite 47 disc drives are factory set with the SCSI ID set at
0. To change the SCSI ID, install jumpers on the appropriate pins
as shown in Figure 2.
Figure 2.
Setting the SCSI ID
If, after completing the installation process, the drive’s LED does
not show on/off activity when the host is trying to communicate
with the drive, a duplicate SCSI ID may be the problem. If this is
the case, change the ID so that each device on the SCSI chain
has its own unique ID. Also check your system or controller
SCSI ID = 0 (default)
J4A
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8*
SCSI ID = 9*
SCSI ID = Ah (10)*
SCSI ID = Bh (11)*
SCSI ID = Ch (12)*
SCSI ID = Dh (13)*
SCSI ID = Eh (14)*
SCSI ID = Fh (15)*
Pin 1
Pin 15
J01
J4A
J6
SCSI I/O
Connector
DC Power
Connector
J4B
Pin 1
Pin 1
Summary of Contents for Elite 47
