EchoBoat-G2-RCV Quick
Page 1
5
Guide/User Manual
Rev 2, AUG. 2017
© Copyright 2017 Seafloor Systems, Inc. All rights reserved.
10.1
Futaba Remote Calibration
1.
Turn OFF the power to the thrusters.
2.
Turn OFF Futaba RCU.
3.
Joysticks in the MIDDLE position.
4.
Turn on Futaba RCU, and make sure it is armed (follow steps in Section 7).
5.
RIGHT joystick all the way FORWARD.
6.
Turn ON the power to the thrusters, focus on the right thruster only. Two chimes.
7.
Bring RIGHT joystick back to NEUTRAL (MIDDLE position). Three chimes. System is calibrated.
8.
Turn OFF the power to the thrusters.
9.
Repeat Steps 1 through 7 focus on the LEFT thruster and LEFT joystick.
10. If more than three chimes are heard, repeat the process.
These steps are shown in the HyDrone Video Troubleshooting Guide
https://www.youtube.com/watch?v=HOdkXY_Ik7w&feature=youtu.be
10.2 Pairing the Futaba Remote
If the Futaba RCU continues to chirp more than two times when turning it on, follow these instructions to re-pair the
RCU with the speed controller:
1.
Turn on Futaba RCU and hold it close proximity to the speed controller in the rear of the boat.
2.
Turn on the power to the thrusters, and focus on the one that needs to be paired.
3.
Locate the speed controller in the boat. Press and hold the small black button labeled “SW” for
approximately 3 seconds.
The RED flashing light indicates it is searching to pair with a Futaba RCU.
Note: If the RED light continues to flash, the Futaba RCU may be too far away to pair.
Even 1 foot away may be too far to pair.
The GREEN solid light indicates it has discovered the Futaba RCU.
11.0
Contacting Technical Support:
Phone:
(530) 677-1019
Email:
Hours:
Monday - Friday, 8:30 a.m. - 5:00 p.m. Pacific Time
Address:
4415 Commodity Way, Single Springs CA 95682
