17. Make sure the seals and sealing surfaces are clean
and lubricated before replacing the Inner Nose Cone.
See fig.8
18. Replace the Inner Nose Cone making sure the key is
aligned correctly. See fig. 9.
19. Ensure the Vent O Ring is fitted correctly. See fig. 10.
20. Screw in the Vent Plug to seal the vent.
9. Remove the battery and place on a level surface.
10. Connect the battery cable to the charger cable.
11. Plug charger into mains, and turn on the supply.
12. Charging will take 14 to 16 hours for a fully discharged
battery. Flashing light indicates battery is fully charged.
13. Unplug the adapter from the mains.
14. Allow battery to stand for 30 minutes before using it.
15. Unplug the battery cable from the Charger cable.
16. When ready for use, install the battery and reconnect to
the housing cable.
14
15
Fig.6
Press here to release and pull to disconnect
Fig.7
Fig.8
Ensure sealing surface is clean
Ensure the seals are
clean and lubricated
Seals
Close up view
of seals
