FINAL PREPARATION
4–TEC SC Models
CAUTION:
If watercraft is not on water area,
make sure to cool engine using flush kit,
otherwise, the engine and/or the exhaust system
may be severely damaged.
- Warm-up engine then let
idle for 30 seconds
before stopping.
- Stop engine.
-
Wait at least 30 seconds
then pull dipstick
out and wipe clean.
WARNING
Engine oil may be hot. Certain components in
the engine compartment may be very hot. Direct
contact may result in skin burn.
CAUTION:
Never run engine longer than 5
minutes. Drive line seal has no cooling when
watercraft is out of water.
1
3
2
F18D2N6
- Reinstall dipstick, push in completely.
- Remove dipstick and read oil level. It should be
between marks [[[[3]]]].
• Mark [[[[1]]]] for
FULL
.
• Mark [[[[2]]]] for
ADD
.
- Otherwise, add up oil to have the level between
marks as required.
1
F18D086
- To add oil, unscrew oil cap [[[[1]]]]. Place a funnel into
the opening and add the recommended oil to the
proper level.
Do not overfill
.
- Properly reinstall oil cap and dipstick.
Ending a B.U.D.S. Session
Click on FAULT tab and check if there are active
faults.
If so, service watercraft then clear the faults in
B.U.D.S.
10 / 15
2004-1
Predelivery
