Sea Tel DAC-03, Installation And Operation Manual

Page: 57 / 80

DAC-03 Tracking Antenna Controller Maintenance & Troubleshooting
7-7
For each line of hex data that is programmed
during the ACU software upload procedure
ProgTerm will display one of the following
characters:
“
*
” (successful programming),
“
_
“ (failed programming),
“
!
” (protected memory access)
If you see any “_” characters while
programming it means that the ports did not
get locked properly and you must stop the
upload (by pressing
Cancel to abort)
immediately and restart the upload sequence.
15.
If the bootload is successful, the module
will reboot, you may not see any text
after the last S9 record, but it will
respond correctly to the Paper Clip and
EyeBall tool bar button requests to
display the new versions you just loaded
in. In this case, you are done.
16.
If the bootload was unsuccessful, you
will see checksum and bootloader
version displayed. In this case, repeat
the upload procedure.