Sea Tel 9797B-70 C-Band TX/RX, Installation And Operation Manual

Page: 14 / 110

Operation 9797B-70 C-Band TXRX
2-2
2.4. Stabilized Pedestal Assembly Operation
Operation of the stabilized antenna Pedestal Control Unit (PCU) is accomplished remotely by the Antenna Control Unit
(ACU). Refer to the Operation section of the Antenna Control Unit manual for more specific operation details. There
are no other operating instructions applicable to the pedestal assembly by itself.
2.5. Tracking Operation
Tracking optimizes the antenna pointing, in very fine step increments, to maximize the level of the satellite signal
being received. The mode of tracking used in this antenna is a variation of Conical Scanning called DishScan.
DishScan continuously drives the antenna in a very small circular pattern at 60 RPM. The ACU evaluates the received
signal throughout each rotation to determine where the strongest signal level is (Up, Right, Down or Left) and issues
the appropriate Azimuth and/or Elevation steps to the antenna, as needed.
You cannot control tracking from the pedestal itself. Refer to the ACU manual for tracking operation information.
2.6. Antenna Polarization Operation
Your Scalar Plate assembly is equipped with a polarization motor and potentiometer feedback that are controlled from
the Antenna Control Unit. This allows you to have a Linear, or a Circular, feed assembly installed on your antenna.
When you have a Circular feed installed, polarization adjustment. is NOT required. You should set the POL TYPE
parameter in your ACU to 0000.
When you have a Linear feed installed, polarization may be operated manually from the ACU but Auto-Polarization
mode is the default polarization mode of operation from the ACU and is strongly recommended (set POL TYPE
parameter in your ACU to 0072). Refer to the Antenna Control Unit manual for more operation information.
2.7. Low Noise Block Converter Operation
There are no operating instructions or controls applicable to the LNB. This unit is energized by the ACU (or by the
pedestal modem on some systems).
2.8. RF Equipment
The RF Equipment is not operated or controlled by the antenna pedestal or Antenna Control Unit. Refer to the vendor
supplied manuals for the RF Equipment provided with your system.
2.9. Radome Assembly Operation
When operating the system it is necessary that the radome access hatch (and/or side door) be closed and secured in
place at all times. This prevents rain, salt water and wind from entering the radome. Water and excessive
condensation promote rust & corrosion of the antenna pedestal. Wind gusts will disturb the antenna pointing.
There are no other operating instructions applicable to the radome assembly by itself.