Sea Tel 6012-33, Nstallation Manual

Page: 91 / 142

Stowing the Antenna 6012-33 Installation Manual
17-5
2. To un-stow the antenna, remove the pin bolt
from the LOCK position.
3. Install the pin bolt into the STOW hole and
tighten. This assures that it does not get lost
and will be ready for re-use if the antenna
needs to be stowed again at a later date.
4. Verify that the antenna is able to rotate freely
in azimuth.
17.2.2. Removing the EL Shipping/Stow Restraint
1. The EL shipping/stow restraint is formed by a
stow pin-bolt mounted through a bracket and
is engaged into a hole/slot in the elevation
driven sprocket when the dish is at zenith (90
degrees elevation).
2. In the stowed position, the hardware from left
to right is stow pin-bolt head, washer, bracket,
washer, hex nut, hex nut so that the pin
section of the stow pin-bolt is inserted into
the hole in the elevation driven sprocket.
EL Stow Pin-Bolt head
Bracket
2 Hex Nuts
Pin inserted into Elevation Driven Sprocket
Elevation Driven Sprocket