Sea Tel 5009-17, Installation Manual

Page: 34 / 145

5009-17 Installation Manual Installation
3-14
provided. 126865-1 supplies 8Vdc @ 1Amp, while the 126865-2 assembly supplies 5Vdc
@ 2Amps.
•
GND
Screw terminal is the ground reference for the regulated and unregulated power
terminals.
•
12/24
Screw terminal is commonly used to provide operating voltage to a external GPS,
Dual Antenna Arbitrator or other below decks tone generators or switches. Voltage output
is based on the T.M.S assemblies JP5 jumper settings.
3.7.7.7. TS5 NMEA A/B, GPS output.
•
RxA- and RxA+- screw terminals, which are
defined as the NMEA A connection is used to
connect to the ships Gyro Compass (Heading). The
NMEA0183 compliant inputs are then connected
via a 9 pin ribbon cable to the ACU’s J2 NMEA
communications port. A GPS (Latitude and
Longitude) input may also be connected, but is not
required because there is a GPS device already
installed in your antenna..
NOTE:
If you connect a
ships GPS to the terminal mounting strip, you
MUST
disconnect the GPS antenna on the
antenna pedestal.
•
RxB- and RxB+ screw terminals, which are defined
as the NMEA B connection is used to connect to
the ships Gyro Compass (Heading). The
NMEA0183 compliant inputs are then connected
via a 9 pin ribbon cable to the ACU’s J2 NMEA
communications port. A GPS (Latitude and
Longitude) input may also be connected, but is not
required because there is a GPS device already
installed in your antenna.
•
TxA- screw terminal is used to provide a Pseudo GPS (GGA and GLL formats) output to
other system components such as a Satellite Modem.
3.7.8.
Connect your other Below Decks Equipment (ie, telephone, fax machine and computer equipment) to
complete your configuration.
Other BDE connections
3.8. Final Checks
3.8.1.
Do a visual inspection of your work to assure that everything is connected properly and all cables/wires are
secured.
Visual/Electrical inspection
3.8.2.
Double check all your connections to assure that it is safe to energize the equipment.
Electrical - Double check wiring connections
3.9. Power-Up
Verify that all shipping straps and restrains have been removed prior to energizing the antenna.
When all equipment has been installed, turn ACU Power and Antenna power ON. The ACU will initially sequentially
display:
“SEA TEL – MASTER and DAC-2202 VER 6.xx” followed by,
“SEA TEL – RCVR and SCPC VER 5.xx” followed by,
“SEA TEL – IO MOD and COMMIF VER 1.xx” followed by,
“SEA TEL – REMOTE and INITIALIZING”. After initialization, the bottom line of the remote display will display
the antenna model number and the software version from the PCU.
Energize and check the other Below Decks Equipment to verify that all the equipment is operating. You will need to