Sea Tel 4009-9 BROADBAND-AT-SEA, Installation Manual, Page: 25 / 153

Installation 4009-9 Installation Manual
3-3
4. Remove four equally spaced bolts around
the radome flange. Save these nuts and
bolts to be reinstalled later.
5. Install four lifting eyebolts in the vacant
holes in the flange of the radome..
(Hardware provided in the radome
installation kit). Keep the original perimeter
bolt hardware to be reinstalled after the
ADE has been installed.
6. Attach shackles and four part web lifting
sling arrangement to the eyebolts.
7. Attach a suitable length tagline to one of
the eyebolts.
8. After hoisted into place the lifting eyes are
to be removed and replaced with the
stainless hardware that was removed in step
4 (the eyes are galvanized with bare thread
that will rust if left exposed to the weather).
3.3.2. Installing the 50, 60 or 66” Radome Assembly
The antenna pedestal is shipped completely assembled in its radome.
1. Man the tag line(s).
2. Hoist the antenna assembly off the shipping pallet,
by means of a suitably sized crane or derrick, to
allow access to bottom of radome assembly.
3. Open the hatch by pressing the round release
button in the center of the black latches and gently
push the hatch up into the radome. Place the
hatch door (gel coat surface up) inside the radome
on the far side of the antenna pedestal.
4. Inspect the pedestal assembly and reflector for
signs of shipping damage.
5. Peel the paper off of the mounting pad (provided
in the radome installation kit) to expose the sticky
side of the pad, align it to the mounting holes and
press it in place on the underside of the radome
base.