Sea Ray 44 Sedan Bridge, Owner'S Manual

Page: 48 / 218

44 Sedan Bridge ( 455 Sedan Bridge )
2.16
S
ECTION
2 • G
ENERAL
B
OAT
A
RRANGEMENT
2. CRUISE 1/OFF/CRUISE 2 : The cruise feature
provides two (2) adjustable engine speeds. The
cruise control can be used to run the engines at
the optimal cruise rpm or trolling rpm.
CRUISE 1 has a default setting of 2100 rpm.
CRUISE 2 has a default setting of 1200 rpm.
NOTE: The marine cruise control feature can be
used in conjunction with the engine syncronization
feature.
3. SLOW IDLE : The SLOW-IDLE feature allows
for lower idle speed for operation in “No Wake
Zones”. When activated, the SLOW-IDLE
feature reduces the engine speed to 550rpm.
4. RPM +/- : The engine speed control switch allows
the idle speed to be adjusted in 25 rpm
increments by pressing the rocker switch.
Pressing the top of the rocker switch
INCREASES engine rpm.
Pressing the bottom of the rocker switch
DECREASES engine rpm.
NOTE: Use slow deliberate clicks to increase or
decrease the engine rpm.
S
TANDARD
E
NGINE
S
YNCHRONIZER
:
1. WAIT TO START: The WAIT TO START lamp is
only used on engines with an intake air heater
system such as B-series and C-series engines.
2. STOP ENGINE: The STOP ENGINE light is a
red lamp which indicates that the engine needs
ENGINE
SYNC
CRUISE 1
OFF
CRUISE 2
RPM
+/-
SLOW
IDLE
PORT
STBD
WAIT
TO
START
ENGINE
MAINT.
STOP
ENGINE
CHECK
ENGINE
WAIT
TO
START
ENGINE
MAINT.
STOP
ENGINE
CHECK
ENGINE
E
NGINE
S
YNCRONIZATION
S
WITCH
P
ANEL
(O
PTIONAL
)
(F
IG
. 2.16.1)
to be shut down before permanent damages
occurs to the engine.
NOTE: If the STOP ENGINE LIGHT is activated,
the engine MUST be shut off as soon as it can be
shut off safely. The engine MUST NOT be run until
the fault is corrected.
This lamp is also used to flash out the fault code
number in the diagnostics mode.
3. ENGINE MAINT.: The ENGINE MAINT. lamp is
activated when engine maintenance is required.
4. CHECK ENGINE: The CHECK ENGINE lamp
is activated during a non-fatal system error. The
engine can still be run, but the fault must be
corrected as soon as possible.
NOTE: In the diagnostics mode, the CHECK
ENGINE lamp displays in three (3) digit fault codes.
REFER TO OWNER’S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
The engine synchronization feature must be turned
OFF before docking or low speed maneuvering, this
allows full and separate control of each engine. Failure
to turn off the engine synchronization feature can
cause personal injury, damage to the vessel, and/or
the dock.
! WARNING