18
36 S
edan
B
ridge
o
wnerS
m
anual
36 Sedan Bridge
21. m
aCeraTor
d
isCharge
p
ump
w
/ s
eaCoCk
i
nTerloCk
s
ysTem
(o
pTional
)
The optional macerator
gives the boat operator
the means of discharging
the holding tank contents
directly overboard through
a seacock in the bottom of
the hull. This is available
in conjunction with the
dockside pump out.
Since direct overboard
discharge is prohibited
i n m a ny a r e a s, t h e
macerator seacock is
normally closed. The
macerator seacock is
equipped with a system
interlock switch which
prevents the operation of
the macerator when the
macerator seacock is closed. The ENABLE button
on the ESIP in the salon will be lighted when the
macerator is operational. If the light is not lighted,
it is visual confirmation the macerator seacock is
closed and that the macerator cannot be operated.
Check that the macerator seacock handle is in the
open position and the light on the switch is lighted
before operating the macerator.
T
o
o
peraTe
The
m
aCeraTor
:
1. Touch and release the ENABLE button on the
ESIP in the salon and open the overboard
discharge seacock located on the bilge floor .
2. Touch and release the PUMP button on the
ESIP.
3. When tank is empty, turn off the switch, touch
the ENABLE button to turn the system off and
close the waste discharge seacock.
(f
ig
. 18.1)
(f
ig
. 18.2)
22. r
efrigeraTor
& f
reezer
The refrigerator/freezer
unit located in the galley
is supplied power by
the REFRIGERATOR/
F R E E z E R b u t t o n
on the salon 120 volt
DCdistribution panel. To
operate dockside, connect
the shore power system,
turn the MAIn breaker(s)
ON. Then touch and release the REFRIGERATOR/
FREEzER
button on the AC systems page on the
ESIP.
a. C
oCkpiT
i
Ce
m
aker
(o
pTional
)
The cockpit ice maker is
located on the portside
of the cockpit in the wall
of the bridge steps. To
operate, touch and release
the REFRIGERATOR/
FREEzER button on the
DC systems page on the
ESIP.
T
o
s
TarT
i
Ce
m
aker
:
1. Make sure water tank
is full.
2. Tu r n t h e f r e s h
w a t e r p u m p O N
by t o u c h i n g a n d
releasing the FRESH
WATER button on the
tanks page on the ESIP panel in the salon.
3. Turn ON ice maker switch, located at the bottom
of the unit. Allow unit to cycle several times
before using ice. Refer to water system for more
information.
REFER TO OWnER’S Manual PACKET FOR
InSTRuCTIOnS AnD WARRAnTy InFORMATIOn
(f
ig
. 18.3)
(f
ig
. 18.4)
(f
ig
. 18.5)
