Page
12
of
38
1.3.3 What happens when the unit is transmitting on full power? The unit will make a BEEPING sound
and the antenna LED section will flash
GREEN
, followed by flashing
RED
LEDs in an SOS pattern this will
continuously cycle until the unit is switched off.
1.4.0 SWITCHING THE AU9 OFF – DISENGAGING THE BATTERY
Fig. 11
1.4.1 Lift the rubber ‘O’ ring (no. 6) out and down, slide the side switch (no. 11) UP until it clicks. The
unit will stop transmitting within a few seconds, the unit will ‘BEEP’ once to indicate it has been
switched OFF.
1.4.2 SWITCHING THE UNIT OFF FROM AUTOMATIC OVER RIDE ACTIVATION - The unit will continue to
transmitt on full power until manually switched OFF by moving the side ARMING switch DOWN & then
immedaitely back UP until it positively clicks.
Applies to units fitted with 40 second override function
only, the instruction label on the rear of your unit will indicate if your unit has this function installed
or not
Fig. 12
