13
FastCat14.4 | ASSEMBLY & INFLATION
Slide seat onto seat release.
When seat is fully pushed
into seat release, the
locking mechanism will pop
down with a click.
To remove seat, lift the
locking tab and slide seat
out.
To swivel the seat, pull
locking bar forward then
turn the seat.
The FastCat14.4 has a large
D-ring located under the
front chamber. The D-ring
can be used as an
attachment point for a
trailer winch or to hook up
to a mooring.
Warning:
It is not
recommended to tow the
boat with this ring except at
low speed.
Cooler (Not included or
sold by Sea Eagle)
Two D-rings are installed
on the floor aft of the
transom for strapping on a
cooler or utility box. Cooler
should be smaller than 54
gallon capacity and have
two handles or slots for
strap.
Motor (OPTIONAL)
Clamp electric motor or
up to a 20hp gas motor to
motor mount. Turn clamp
screws until tight.
Caution:
Check motor
clamp screws frequently,
tighten if needed.
To move the FastCat14.4
manually, use the included
66” paddles. When not in
use, stow paddles on floor.
Match up the holes in the
pedestal with the holes in
the swivel. Insert screws
one at a time and hand
tighten the locking nuts.
When all four screws are
installed, use two wrenches
to tighten each locking
nuts.
