8
SU11 LongBoard
AB-30 Kayak Paddle
This four-part paddle comes
with right and left blades, two
shaft pieces and two drip guards.
Put the shaft together first. In-
sert the shaft piece with the but-
ton into the piece with three
holes. Lock the button in the
middle hole.
Next, slide the drip guards
up the shaft to about an
inch above the button hole.
Insert the blades into the
shaft and adjust until the
button locks the blade in
place.
The additional holes in the
shaft are for “feathering”
the blades. Blades can be
offset 45° from each other.
This makes paddling into a
stiff breeze easier as the
blade that is not in the
water will be able to slice
through the wind with little
resistance.
ASSEMBLY & INFLATION
Insert the adapter into the valve
and inflate the chambers. The
back takes 12-14 strokes to in-
flate and the base takes 6-7
strokes.
Run the strap through one of
the D-rings behind the seat.
Run it around the seat and
through the D-ring on the
other side. Run the free end up
through the middle of the
buckle and down through the
front. Pull it tight.
Stand Up Paddle
This three-part paddle has
a T-handle, shaft and blade.
Insert the blade into the shaft
and align the hole with the
button to lock in place. Insert
the T-handle and adjust to the
desired length.
Carbon Fiber SUP
(OPTIONAL)
This three-part paddle has car-
bon fiber T-handle, shaft and
blade blade sections.
Insert the blade into the shaft and align the hole with the button.
Insert the T-handle and adjust to the desired height. Lock with the
thumb lock.
