Sea-doo Speedster 200, Operator'S Manual

Page: 53 / 130

53
Pump System
(water ballast bag)
(optional)
Follow the manufacturer’s instructions
that are supplied for use.
CAUTION: Never tow boat with the
ballast bag filled; always empty bal-
last bag before towing. Never empty
ballast bag into bilge area of boat.
Towing Tower
CAUTION: Towing tower MUST be
fastened in the upright position to
avoid damage to the boat and tow-
ing vehicle while in transport or wa-
ter operation.
To raise tower for transport and use
NOTE: To raise tower will require 2
people.
Remove set screws from rear tower
attachment points using a 3/32 in Allen
wrench.
Slightly press down on socket plug
and push lock button away from plug
to remove from socket.
TYPICAL
1. Set screw
2. Lock button
3. Socket plug
4. Slide lock button (2) in this direction
Save socket plugs for later use.
With one person holding tower at cen-
ter, install port or starboard upright into
socket.
Place upright in position and screw
knobs into upright and tighten as
shown.
TYPICAL
1. Port upright with knobs installed

WARNING
Only use ballast bag for skiing/
wakeboarding purposes. Ballast
bag must always be in the ski lock-
er when full.

WARNING
Pulling a tube, skier or wakeboarder
makes the boat handle differently
and requires greater skill. Unless ab-
solutely necessary, do not make
tight, sharp turns. Keep a safe dis-
tance from docks, swimmers, other
craft or objects. Be advised that seri-
ous injury can result if the tow rope
becomes slack during a tight turn or
when circling. The rope could be-
come wrapped around the neck or
limbs of a person.
F13L2VY
4
3
2
1
F13L2WY
1
lmo2005_002a.book Page 53 Tuesday, July 6, 2004 3:44 PM