Trouble Shooting
22
21
1. Remove the SEASCOOTER
™
from the water.
2. Make sure the Safety Lock is in the "Off" position.
3. Disconnect and remove the battery - see page 16, step1-6.
4. Unscrew the eight Rear Grille screws as shown in fig. 11.
Unit does not function
If the motor does not start when both triggers are pressed,
make sure:
1. The battery is properly connected
2. The battery is fully charged
(see page 16, charging the battery)
3. The Safety Lock is in the "On" position
(see fig 5a, page 11)
4. There is no water in the battery compartment
(see page 24, accidental flooding)
Blocked Propeller
If the Propeller becomes blocked the Rear Grille and
Propeller can be removed, to remove the obstacle.
Removing rear grille and Propeller to remove obstruction
5. While holding the Propeller, use an M6 socket to
remove the nut from the Propeller shaft (See fig. 12).
6. Slide the Propeller off the shaft, taking care not to loose
the drive pin or washers.
7. Remove the blockage from the Propeller.
8. Replace the drive pin (if removed), see fig. 13, and
Propeller. Turn the Propeller slowly until you locate the
pin and push the Propeller fully on.
Fig.11
Fig.12
Warning!
Crushing / Cutting Hazard
Before opening the grille for maintenance purpose, make
sure the master switch is in off position, and the battery is
disconnected.
