Sea-doo MOVE Trailer, User Manual

Page: 14 / 51

TRAILER SET-UP
MOVE I and II with Winch
Set tongue weight, bow stopper roller,
and bunks as follows.
NOTE: For these trailers, the axle
must be kept in factory postion all the
time.
Tongue Weight
Move winch support towards front or
rear of trailer in order adjust tongue
weight.
The tongue weight should be from 3
to 10% of the total trailer and PWC
weight with tongue parallel to the
ground.
To adjust, loosen the 4 nuts under-
neath the winch support U-bolts, move
winch support to the desired position,
then tighten nuts as per the following
table.
TIGHTENING TORQUE
Winch support
U-bolt nuts
27 N•m ± 3 N•m
(20 lbf•ft ± 2 lbf•ft)
smo2010-003-025_a
1. Winch support U-bolts nuts
Bow Stopper Roller
Set bow roller stopper so that it leans
on the PWC bow between rubber
bumper and bow eyelet (or bow cup
on selected models).
To adjust:
1. Loosen the 2 nuts underneath the
front winch support U-bolt.
2. Remove the winch arm adjustment
bolt.
3. Set the bow roller stopper to the de-
sired height, then lock it in position
by inserting the bolt through the
aligned winch support and winch
arm holes.
smo2010-003-025_b
1. Winch arm
2. Winch arm adjustment bolt
3. Winch support
4. Front U-bolt nuts
4. Tighten the fasteners according to
the following table.
TIGHTENING TORQUE
U-bolts nuts
27 N•m ± 3 N•m
(20 lbf•ft ± 2 lbf•ft)
Winch arm
adjustment
bolt
27 N•m ± 3 N•m
(20 lbf•ft ± 2 lbf•ft)
Bunks
The wooden bunks are preset to suit
all Sea-Doo personal watercraft (PWC)
hull designs, however, a universal
rule applies: bunks must lean square
against a plain area of the hull.
Make sure the bunks are well posi-
tioned.
To adjust:
1. Loosen the 2 nuts underneath the
bunk when the PWC is not on the
trailer.
12
______________