45
Cover spark plug holes with a rag.
Ensure choke lever is completely pushed
in.
Crank engine for approximately 10
seconds to allow water to escape from
spark plug openings.
Spray BOMBARDIER LUBE lubricant
or equivalent into spark plug holes.
Crank engine again.
Reinstall spark plugs.
Start engine normally.
Towing the Craft in Water
Special precautions should be taken
when towing a craft in water.
Maximum recommended towing speed
is 24 km/h (15 MPH).
When towing your craft in water, pinch
the water supply hose from the impel-
ler housing to the engine with a large
hose pincher (P/N 529 032 500) shown
in the following illustration.
This will prevent the cooling system
from filling which may lead to water
being injected into and filling the ex-
haust system. Without the engine run-
ning there isn’t any exhaust pressure
to carry the water out the exhaust out-
let.
CAUTION:
Failure to do this may re-
sult in damage to the engine. If you
must tow a stranded craft in water
and do not have a hose pincher be
sure to stay well below the maxi-
mum towing speed of 24 km/h (15
MPH).
Snugly install the hose pincher on the
water supply hose as shown.
TYPICAL
1. Hose pincher
CAUTION:
When finished towing
the craft, hose pincher should be re-
moved before operating it. Failure
to do so will result in damage to the
engine.
Low-Charge Battery
Condition
See your authorized Sea-Doo dealer to
have it charged or replaced.
F01B23Y
WARNING
Do not charge or boost the bat-
tery while installed on the craft.
F07E03Y
1
smo2000-001b.fm Page 45 Tuesday, May 4, 1999 1:35 PM
www.SeaDooManuals.net
