Sea-doo GTX Limited iS 255 2009, Shop Manual

Page: 58 / 555

Section 02 ENGINE
Subsection 03 (INTAKE MANIFOLD)
1
R1503motr62A
INTAKE MANIFOLD
1. Gaskets
First, position intake manifold on front mounting
bracket then push manifold toward engine to then
proceed with rear mounting bracket.
When installing the intake manifold, lift up the oil
dipstick tube a little bit to fit in the slot of the man-
ifold.
R1503motr59B
1
1. Oil dipstick tube
Apply
LOCTITE 243 (BLUE) (P/N 293 800 060)
on the
intake manifold screws.
Torque them to 9 N•m (80 lbf• in ) following the
tightening sequence as shown in next illustration.
smr2009-018-013_a
Ensure to properly route and secure wiring har-
ness with locking ties.
Apply
LOCTITE 243 (BLUE) (P/N 293 800 060)
on the
ECM retaining screws and torque them to 9 N•m
(80 lbf•
in ).
FLAME ARRESTER
Flame Arrester Location
The flame arrester is integrated in the intake man-
ifold.
smr2009-018-014_a
1. Flame arrester
Flame Arrester Inspection
The flame arrester in the intake manifold is main-
tenance free.
Flame Arrester Replacement
NOTE: The flame arrester can not be removed
from the intake manifold.
Replace intake manifold if necessary. Refer to
IN-
TAKE MANIFOLD
in this subsection.
smr2009-018
35