Section 09
PROPULSION SYSTEM
Sub-Section 03
(REVERSE SYSTEM)
09-03-4
CAUTION : Always hook reverse gate
springs in order to ease reverse gate oper-
ation.
1. Screws, washers and sleeves
6, Reverse Support
For reverse support installation, torque screw to 8
N•m (71 lbf•
in
) and Allen screws to 2 N•m (18
lbf•
in
).
4,5, Triangular Lever and Sliding Block
Insert bushing in triangular lever and then install
lever to reverse support.
TYPICAL
1. Bushing
Install reverse cable to triangular lever with bush-
ing, plastic washer(s) and flat washers.
Torque cable screw to 7 N•m (62 lbf•
in
).
Torque triangular lever screw to 8 N•m (71
lbf•
in
).
Install sliding block to lever and torque nut to 8
N•m (71 lbf•
in
).
1,5, Locking Lever and Sliding Block
Insert locking lever end in support hole then align
lever and sliding block holes.
TYPICAL
1. Support hole
1,3,5, Locking Lever, Selector Lever and
Sliding Block
NOTE :
Always install selector lever with its
open end facing left side of watercraft, then
push selector lever stem through locking lever
and sliding block holes.
TYPICAL
1. Install lever as shown
-
F02J02B
1
F02J0CA
1
F02J0DA
1
F02J0EA
1
www.SeaDooManuals.net