Sea-doo Aqua Master SD75004, User Manual, Page: 8 / 16

19. Ensure the Vent O Ring is fitted correctly (See Fig.8).
20. Screw in the Vent Plug tightly to seal the vent (See
Fig.9).
21. Replace the Buoyancy
Foam (See Fig.10).
Charging the battery
For Battery charging follow these instructions.
1. Always ensure that the Master Switch is OFF (See
Fig.16).
2. Always ensure that the SEA-DOO
®
AQUA MASTER is
out of the water, dry and placed in a dry area.
3. Lift and rotate the Latches and remove them from the
Nose Cone (See Fig.11).
4. Remove the Nose Cone and Buoyancy Foam.
5. Open the Vent Plug by unscrewing it (See Fig.2).
6. Remove the Inner Nose Cone. To do this, first feed the
silicone ring (provided with this manual) through the
latch holes in the Inner Nose Cone and hook over the
hooks on the Battery Housing (see figure 3). Then screw
the Pump Nozzle onto the Vent Hole and pump air into
the Battery Chamber until the Inner Nose Cone pops off
and then remove the silicone ring.
7. Allow two minutes for any gasses to dissipate.
13 12
14. Allow battery to stand for 30 minutes before using it.
15. Unplug the Battery
Charging Socket from
the Charger Jack and
reconnect to the
Battery Housing
Cable.
16. Tidy up the cables
around the battery
(See Fig.5).
17. Make sure the sealing
surface is clean and
lubricated before
replacing the Inner
Nose Cone (See Fig.6).
18. Replace the Inner
Nose Cone making
sure the key is aligned
correctly and the
flange in touch with the
edge of Battery
Housing (See Fig.7).
8. Disconnect the Battery cable from the Battery Housing
Cable by pressing the locking feature (See Fig.4).
(The cable will be disconnected when you first receive
your unit.)
9. Remove the battery and place on a level surface.
10. Connect the Battery Charging Socket to the Charger Jack.
11. Plug Charger into mains, and turn on the supply.
12. Charging will take 6 to 8 hours for a fully discharged
battery. When the battery is charging the LED on the
Charger remains RED, when the battery is charged the
LED appears flashing RED.
13. Unplug the Charger from the mains.
Fig.8
O Ring correctly fitted into
groove and lubricated
Inner Nose Cone
partial enlarged view
Fig.9
Fig.10
Buoyancy
Foam
22. Replace the Nose Cone making sure the key is
aligned correctly. Insert and then rotate the Latches,
you will hear "click" sound once the Latches are
engaged (See Fig.11).
Lift and rotate to unlock
Rotate and click
to lock
Fig.11