Sea-doo 2001 GTS, Operator'S Manual, Page: 50 / 180

CONTROLS
NOTE: If water current is 8 km/h
(5 MPH) or above, the reverse can not
be engaged as the speed threshold for
the reverse is exceeded.
At speeds above 8 km/h (5 MPH),
pulling the iBR lever in will engage the
brake.
When the iBR lever is released after
braking or reverse operation, neutral is
engaged.
WARNING
If the throttle lever is still pulled in
when releasing the iBR lever, for-
ward movement will be initiated
after a short delay. If forward ac-
celeration is not desired, release
the throttle lever.
NOTE: The neutral position can be fine
tuned by trimming the iBR system.
Refer to OPERATING INSTRUCTIONS
subsection for detailed instructions.
6) MODE/SET Buttons (All
Models Except GTS)
These buttons are located on the RH
side of the handlebar.
Press MODE button to scroll through
various functions available through the
information center.
Press SET button to select the desired
function, navigate through a function
submenu, or to save any modified set-
ting.
sdd2009-001-024_b
TYPICAL
1. MODE
2. SET
3. UP/DOWN button
Refer to OPERATING INSTRUCTIONS
subsection for detailed instructions.
7) UP/DOWN Buttons (All
Models Except GTS)
These buttons located on the RH side
of the handlebar.
smo2012-003-007_b
TYPICAL
1. Up button
2. Down button
The UP/DOWN buttons are used to
make a selection or change a setting
through the information center such
as:
– Gauge functions
– Ski mode
– Cruise mode
– Slow speed mode
– iBR neutral adjustment.
48
______________