SE Munro Egg 150, Operation Manual

Page: 5 / 12

IMPORTANT NOTICE
Ensure the mains voltage selector switch is in the correct position before connecting
to the mains power supply.
Dual Input Amplifier (Control Unit)
Rear Panel
Main Inputs
Industry standard balanced XLR connectors with swit4/-10dB sensitivity. Pin 2 is +ve
Aux Inputs
Unbalanced RCA Phono connectors for consumer level (-10dBu) equipment.
HF Trim
The HF trim pots are designed to give absolute precision alignment of each channel and adjustment for personal taste. When
set to maximum (fully clockwise) the tweeters are at maximum sensitivity. The graduation is approximately -1dB at 10 kHz for
each 45 degrees of anticlockwise rotation.
LF Trim
The LF trim allows adjustment for speaker location and room acoustic effects. The reference (flat) setting is fully clockwise
and up to 10dB of roll-off at 63Hz is available on each channel. See diagrams on page 5 for frequency range.
Outputs
The speaker connectors are industry standard 4 way Speakons with unique (foolproof) polarity alignment. The cables supplied
with each Egg system are very high quality, impedance matched multicore and under no circumstance should these be
changed or extended without advice from sE Munro. See diagram for pin connections.
LED
The focal point aiming LEDs on the speakers can be switched off once the system is aligned and no further adjustment is
likely. See page 3 for more information.
Voltage Selector
The voltage must be set to the appropriate value and the fuse is designed to protect the Egg system from excessive current
flow. Fuses should only ever be replaced with one of the correct value.
1
2
3
4
5
6
7
2
3 4
5
6
7
The Medium EGG 150 System
The Egg 150 System
Operation Manual
2
1