Se-Kure Controls,
®
Inc.
3714 Runge Street • Franklin Park, IL 60131 • 1-(800) 322-2435 • (847) 288-1111 • Fax: (847) 288-9999
Rev.
11
/
12
/09
SCI-9922
©2009 Se-Kure Controls,
®
Inc.
On the Web: www.se-kure.com
E-Mail: [email protected]
5.
Run the SK-122-PWR-25
Connecting Cable
and the
power wire
(
from the bottom
of the stand) down through
the base plate & hole.
6.
Replace the Stand onto the
mounted base plate
and secure
it with the 3 security screws you
removed earlier. Use the security
bit driver or
SKP-190T
wrench.
7.
Plug the SK-122-PWR-25
connecting cable into one of
the ports on the Alarm
Module.
8.
Plug the SK-295P
Adapter
into a standard 110v
live outlet somewhere nearby.
Standard
110v
Outlet
9.
Clean the area on the
device
where the sensor will
be applied
with Alcohol Prep
Pads.
10.
While the
Alcohol is still wet,
Dry the area
with a
clean
paper towel
.
11.
Remove
the Clear
Backing Sheet
from the
Sensor Adhesive
.
13.
Plug the
Power Adapter
into power jack on the device.
14.
Connect the power
cable on the sensor to the
Power Adapter
you just
installed on the device.
Then place the device on
the stand.
12.
Press the Sensor
firmly
onto the device so it will align
properly on the stand.
SK-PS-126-S
Adapter
Follow the Battery
& Installation
Instructions
that came with your
Alarm Module.
To find the Adapter for your
device, contact your
Se-Kure Controls Customer
Service Representative.
Display Shelf
SK-T12P
Alarm
Module
SK-122-PWR-25
2' Connecting Power
Cable from the
Vantage II Stand
to the SK-T12 Alarm
Module
SK-295P Adapter
SK-584P
Vantage II
Stand with
GPS Unit
Completed Display
