8. IR:
IR Remote Sensor Wire input port
FM Mode
FM Mode is the default mode. A USB flash drive or SD card (with MP3
format files) needs to be inserted to switch between modes. If the unit
does not recognize the files, it will switch to FM Mode automatically.
1)
Press the PLAY/PAUSE button or CH on the remote to begin scan
2)
The system will scan and preset stations depending on location/reception
3)
Allow the scan/preset to finish before pressing other buttons
4)
After scan is done, use PREV or NEXT to switch between preset stations
5)
Stations/frequencies can be selected manually using CH-/+ or the number
keys on the remote
Warning
Continued exposure to sound at excessively high volume may cause hearing
loss or damage. Listening to audio equipment at a high volume level while
operating a motor vehicle may impair your ability to hear external sounds
such as horns, warning signals, or emergency vehicles, thus constitute to
potential traffic hazards. Please use caution.
Mobile Audio Installation (vehicle)
Your vehicles electrical system can power your Active Speaker Box. Carefully and
correctly follow all instructions. If you do not have the technical knowledge or feel
uncertain about an installation, please consult a qualified technician or call our
customer services hotline at 877-997-7888.
Basic wiring needs:
1)
+12V: 12volt constant (power source)
2)
REM: 12volt switch wire (+12V and 0V)
3)
GND: Ground wire (negative)
4)
Audio signal
5)
Optional Cigarette lighter power plug
The Active Speaker Box can be installed as an amplified sub-woofer.
Basic amplifier installation techniques can be applied to facilitate the
installation process or as an additional reference. Connect the following
wires to the power harness; then plug the power harness into your Active
Speaker Box.
1) The 12 volt constant
wire can be gained
directly
from
the
battery’s
positive
terminal or from the
fuse
box.
Directly
wiring to the battery
will simplify the install
process. If connected
directly to the battery,
place a fuse within 16
inches
of
the
connection for safety
purposes.
2) The 12 volt switch
wire (REM) can be
attached from rear of
the radio (aftermarket)
or from an accessory
wire in the vehicles
4
5
6
6