For questions or help with the installation, please call SDHQ Offroad @ 480-633-2929
Mon.
–Fri. 8:00am–5:30pm and Sat. 8:00am–3:30pm Arizona Time. www.sdhqoffroad.com
Page
5
of
7
3.
The air dam behind the grille needs to be removed before
installing the brackets. There are (4) push in clips that will
need to be removed with a flat head screw driver. Circled in
red to the right are the push in clips. Once these are removed,
the air dam can be removed. The air dam can be discarded
as it will not be used.
4.
If the Center Support Kit (SDHQ-53-1110-G3) was
purchased, continue with those Install Instructions.
5. Installing the Brackets
– Starting on the driver side, remove
the (3) nuts pictured below using a 10mm socket and ratchet.
Align the driver side bracket over the studs as pictured. Use
(3) of the supplied M6
– 1.0 Flange nuts with medium strength
Loctite and
tighten them just enough so the mount doesn’t fall. These will be tightened down
later.
6.
Place (1) large fender washer over a
¼” – 20 x ¾” hex head bolt. Place the
hex head bolt and washer through the
rear mounting location connecting the
light mount to the core support. Place
another large fender washer on the
back side of the bolt and begin
threading the lock nut into place with
Loctite.
Use a 7/16” wrench on the lock
nut and a 7/16” socket with the 6”
extension and ratchet to tighten.
Tighten just enough so the mount is
supported. This will be tightened later.
Repeat steps 6-7 for the passenger
side.
