Follow instructions as for non back to back versions substituting the backplate and handle 2, with the coded
plate with the through fixing holes.
Please note that each side may be coded with the same or different codes.
B) The CL600 range is also available to work with most single point panic pads or bars. In this format the
front code plate only is supplied with suitable fixing to connect to most single point panic pads and latches.
If in doubt ask.
To install the PK versions:
Step 1
The position of the CL600PK on the door is determined by the position of the panic device.
Step 2
Mark the position of the spindle hole for the panic device on both sides of the door.
Step 3
Place the CL600PK gasket against the door with the 20mm ( ⁄ ”) hole centred over the mark for spindle hole.
Using the gasket as a template mark the 3 x 10mm ( ⁄ ”) holes for the through fixing bolts. Repeat on the
other side of the door.
Step 4
Drill the 1 x 20mm ( ⁄ ”) hole and the 3 x 10mm ( ⁄ ”) drilling holes, from both sides to avoid splintering out
the face of the door.
Step 5
Countersink the bottom fixing hole as necessary so that the fixing bolt lies flush with the door face,
underneath the panic device.
Step 6
Fit the lever handle to the CL600 front plate and tighten the grub screw in the handle. Enter the code of the
CL600 front unit and check that the lever will turn fully – see page 6. operation check.
Step 7
Fit the CL600 front unit with the 3 fixing bolts. Insert the spindle with the flat blade into the CL600 front unit,
ensuring that the blade is at the correct angle for the hand of door - see diagram page 8.
Step 8
Install the panic device and make sure that the CL600 front unit will fully retract the latch or bolt.
Dimensions
Model CL600/605 For use with existing lock
Model CL610/615 With tubular latchbolt
Model CL620/625 With full ‘Panic Function’ mortice lock & cylinder
II-CL600-v1:0716
© 2018 Codelocks Ltd. All rights reserved.
