TB-9089
Page 2 of 3
© 2018 DESCO INDUSTRIES INC
Employee Owned
SCS
- 926 JR Industrial Drive, Sanford, NC 27332
East: (919) 718-0000 | West: (909) 627-9634 • Website:
StaticControl.com
3. Set the operator test switch to FAIL. The monitor's
red operator 1 LED should illuminate, and its
audible alarm should sound.
4. Set the operator test switch to PASS. The monitor's
green operator 1 LED should illuminate.
5. Insert the verification tester's black operator test
lead into the operator 2 jack of the WSMONITOR2
Plus Workstation Monitor.
6. Set the operator test switch to FAIL. The monitor's
red operator 2 LED should illuminate, and its
audible alarm should sound.
7. Set the operator test switch to PASS. The monitor's
green operator 2 LED should illuminate.
8. Disconnect the operator test lead from the monitor.
VERIFYING THE MAT CIRCUIT
9. Connect the included stacking snap to the
verification tester's white mat test lead.
10. Disconnect the monitor's black mat monitor cord
from its worksurface mat and turn it over to expose
its 10mm snap.
11. Connect the verification tester's white mat test lead
to the mat monitor cord's 10mm snap.
Figure 3. Using the Ground Plug Adapter to ground the
WSMONITOR2 Plus
Verification Tester
Operation
VERIFYING THE OPERATOR CIRCUIT
1. Connect the WSMONITOR2 Plus Verification
Tester's green ground lead to equipment ground.
This may be done using the included Ground Plug
Adapter or alligator clip. See Figure 3.
2. Insert the verification tester's black operator test
lead into the operator 1 jack of the WSMONITOR2
Plus Workstation Monitor.
Figure 4. Connecting the WSMONITOR2 Plus
Verification Tester to the operator jack of the
WSMONTIOR2 Plus Workstation Monitor
Figure 5. Connecting the WSMONITOR2 Plus
Verification Tester to the mat monitor cord of the
WSMONITOR2 Plus Workstation Monitor
Mat Monitor Cord of
WSMONITOR2 Plus
Workstation Monitor