TB-9023
Page 13 of 16
© 2017 DESCO INDUSTRIES, INC.
Employee Owned
SCS
- 926 JR Industrial Drive, Sanford, NC 27332 • (919) 718-0000 • Website:
StaticControl.com
Figure 35. Locating the Data Storage button
EM FIELD Data:
(EM field meter) (Units) (Interval)
(Average) (Date) (Peak) (Average
record) (Time)
POWER DENSITY Data:
(Power density meter) (Interval)
(Average) (Reference) (Date) (Peak)
(Average) (Time)
EIRP Data:
(EIRP meter) (Distance) (Interval)
(Average) (Date) (Peak) (Average
record) (Time)
Data from the microSD card can be exported using
utility software described in the data software section.
RF Signal Sensor Display and
Controls
Menu Function
When the MENU F button is pressed momentarily, the
INTERVAL and AVERAGE data recording timing can be
configured.
INTERVAL, in seconds, is the sampling time for PEAK
data to be recorded onto the microSD storage card.
AVERAGE, in seconds, is the sampling time for
AVERAGE data to be recorded onto the microSD
storage card.
When the MENU F button is pressed for a longer period,
the hardware setup is shown. At this point, brightness,
off-time and attenuation can be adjusted.
Attenuation (ATT): If the input to the antenna is big
enough, set the attenuation from 0 to 20dB.
When the attenuation is set to 20dB, an additional
label of “20dB” is placed along with the “RF Signal” top
heading.
Figure 36. Using the Menu F button
Figure 37. Accessing the Hardware Setup menu
Figure 38. Changing the units of measure
Figure 39. Adjusting the RF Reference settings
RF Units of Measure
When pressed, the units area toggles between dBμV,
dBm and mV units. dBμV –> dBm –> mV
Bar Graph/Reference Display and Button
When the bar graph area is pressed, you can set the
reference level for RF measurement.
With the NAVIGATOR bar:
Press the left or right arrows to adjust RF references.
Press the up or down arrows to move the field cursor.
Press the center button to return to the main screen.
Reference options:
1. Memory Reference
2. Current Reference
To choose between Memory or Current reference, press
“V” (enable) or “X” (disable) at the right side of display.
