TB-9094
Page 4 of 7
© 2019 DESCO INDUSTRIES INC
Employee Owned
SCS
- 926 JR Industrial Drive, Sanford, NC 27332
East: (919) 718-0000 | West: (909) 627-9634 • Website:
StaticControl.com
INSTALLING THE DUAL COMBINATION TESTER
AND STAND
1. Assemble the pedestal and base plate using the 5
socket head screws.
2. Route the ground cord, foot plate cord, and power
adapter through the pedestal. Feed the cords from
the bottom and have them exit through the top.
3. Align the backplate’s two holes located above and
below the tester to the two holes on the pedestal’s
mounting bracket. Secure the backplate using the
two Phillips head screws and nuts.
4. Plug the ground cord into the ground jack located
on the bottom of the tester, and connect the ring
terminal to equipment ground. This connection will
remove any static charge from the user before the
test.
NOTE: Failure to correctly ground the Dual
Combination Tester may result in damage not
covered under warranty.
5. Plug the foot plate cord into the tester and the dual
foot plate.
6. Lay the dual foot plate onto the base plate.
Figure 5. Assembling the pedestal and base plate using
the 5 socket head screws
Figure 6. Securing the Dual Combination Tester to the
pedestal
Figure 7. Installing the dual foot plate onto the baseplate
7. Power the Dual Combination Tester with the power
adapter.