-
20
-
ENGLISH
5.1 At the place where you are going to install
the detector, draw a horizontal line six inches
long.
5.2 Remove the mounting bracket from your unit
by rotating it counterclockwise.
5.3 Place the bracket so that the two longest
hole slots are aligned on the line. In each
of keyhole slots, draw a mark to locate a
mounting plug and screw.
5.4 Remove the bracket.
5.5 Using a 3/16 - inch (5mm) drill bit, drills two
holes at the marks and insert plastic wall
plugs. Put the detector away from getting
plaster dust on it when you drill holes for
mounting.
5.6 Using the two screws and plastic wall plugs
(all supplied), attach the bracket to the wall.
5.7 Line up the slot of the bracket and the
detector. Push the detector onto the
mounting bracket and turn it clockwise to
fix it into place. Pull outward on the detector
to make sure it is securely attached to the
mounting bracket.
5.8 The steps to open the battery cover and to
install the battery are listed as follows:
(1) To power smoke detector requires a battery.
(2) Match terminals on the end(s) of the battery
with opposite terminal connections on the
detector.
(3) When terminals are properly matched, push
battery firmly in until it snaps and cannot be
shaken loose.
DAAF 10Y PS-NOTICE_0314.indd 20
04/04/2014 09:02:09
