ST3134 Operation and Installation Manual
8
Together:
The power output for all channels is controlled from the ST3134 on requirement, but all 4 outputs are
powered in any case in same way.
Permanent:
The power output (+24V DC) for all channels is ON at any time.
Automatic blind addressing:
After KNX Power on or KNX application programming the addressing of the blinds is automatically
performed from the ST3134 with the addresses 1 to 4 (for channel 1 to 4).
Manual blind addressing:
Blind addresses must be set manually for each blind using CTS for Blinds software (special
knowledge about the blind system is necessary).
Blind type
Indicates the blind type connected to all channels as indicated from the blind supplier.
Following Control*
Allows to control from KNX side blinds over each other in same way as a single blind. E.g. 1 + 2
means that the blind on channel 1 is mounted over blind on channel 2. Both blinds are controlled from
KNX side with group objects for channel 1 and group objects for channel 2 do not exist.