Connect 240v/24v Motor Controller Change of Contact State
Programming Procedure To Change Factory Contact State From 2 x Momentary
Contact To A Single Latched Contact.
1. Infra Red receiver must be connected to Connect Motor Controller that you wish to change the contact state input.
2. Disconnect mains power for 20 seconds, then turn power back on.
3. A red program LED will illuminate and the Motor Controller is now in programming mode. Please note it is not
necessary to see this programming light to proceed to point 4, as it is usually contained with a Screen Technics
product and cannot be easily accessed.
4. Please refer to the diagram of the remote control and identify the “Stop 1”and “Stop 2” buttons before proceeding.
Having identified these buttons press them in the following sequence:
STOP 1 / STOP 1 / STOP 2 / STOP 2 / STOP 1 / STOP 2
5. Projection Screen or AV Lifter will acknowledge the reset with a small movement up and down, If the Projection
screen or AV Lifter does not move you will need to start the process
again
6. The contact close state has now been changed from 2 x Momentary
Contact to Single Latched Contact State.
7. This operation does not change the Infra red remote transmitter
operation.
8. To reset the ElectiCinema projection screen or AV lifter to factory
standard please refer to the factory reset instructions – this will return
the ElectiCinema projection screen or AV lifter to factory standard
configuration.
ect
rcv
I
R
M
!
rc
v
I R
"
